The Module System allows the specific combination of different types of pumps, according to your application. Our pumps are made of extremely resistant materials. The functional design facilitates installation and maintenance of the pumps and guarantees their long life.

The rear casing hermetically seals the pump chamber from the driving motor. The driving magnet rotating outside the rear casing transmits the torque of the motor to the inner magnet and thus to the impeller. The impeller is supported by sleeve bearings and a centering shaft made of high-purity oxide ceramic (99.7 %). Thus the bearing is extremely resistant to wear. The use of other bearing materials is possible.

To cool and lubricate the sleeve bearings, part of the fluid delivered passes the impeller and enters the gap between the inner magnet und the rear casing. After flowing through the sleeve bearings, the fluid leaves the casing through special lubricant grooves in front of the impeller.

Type RM 1
Delivery rate:
60 to 2,100 l/h
Delivery head:
up to 5m wc
PP, PVDF, stainless steel

Type RM 1.5
Delivery rate:
60 to 3,600 l/h
Delivery head:
up to 7m wc
PP, PVDF

Type RM 2
Delivery rate:
300 to 7,000 l/h
Delivery head:
up to 9m wc
PP, PVDF

Type RM 2D
Delivery rate:
300 to 6,000 l/h
Delivery head:
up to 16m wc
PP, PVDF

Type RM 2.1
Delivery rate:
60 to 1,320 l/h
Delivery head:
up to 38m wc
PPS, PVDF
self-priming

Type RM 3
Delivery rate:
480 to 12,000 l/h
Delivery head:
up to 23m wc
PP, PVDF, stainless steel

Type RM 3.1
Delivery rate:
500 to 15,000 l/h
Delivery head:
up to 18m wc
PP, PVDF
self-priming

Type RM 4
Delivery rate:
600 to 21,000 l/h
Delivery head:
up to 36m wc
PP, PVDF, stainless steel

Type RM 4.5
Delivery rate:
1,000 to 60,000 l/h
Delivery head:
up to 32m wc
PP, PVDF

Type RM 5
Delivery rate:
2,000 to 30,000 l/h
Delivery head:
up to 60m wc
PP, PVDF