The Module System allows the specific combination of different types of pumps, according to your application. Our pumps are made of extremely resistant materials. The functional design facilitates installation and maintenance of the pumps and guarantees their long life.
The rear casing hermetically seals the pump chamber from the driving motor. The driving magnet rotating outside the rear casing transmits the torque of the motor to the inner magnet and thus to the impeller. The impeller is supported by sleeve bearings and a centering shaft made of high-purity oxide ceramic (99.7 %). Thus the bearing is extremely resistant to wear. The use of other bearing materials is possible.
To cool and lubricate the sleeve bearings, part of the fluid delivered passes the impeller and enters the gap between the inner magnet und the rear casing. After flowing through the sleeve bearings, the fluid leaves the casing through special lubricant grooves in front of the impeller.
Type RM 1
Delivery rate:
0.25 to 8 GPM
Delivery head:
up to 16 FT
PP, PVDF, stainless steel
Type RM 1.5
Delivery rate:
0.25 to 16 GPM
Delivery head:
up to 23 FT
PP, PVDF
Type RM 2
Delivery rate:
1.3 to 31 GPM
Delivery head:
up to 29.5 FT
PP, PVDF
Type RM 2D
Delivery rate:
1.3 to 26 GPM
Delivery head:
up to 52.5 FT
PP, PVDF
Type RM 2.1
Delivery rate:
0.25 to 5.8 GPM
Delivery head:
up to 124 FT
PPS, PVDF
self-priming
Type RM 3
Delivery rate:
2 to 53 GPM
Delivery head:
up to 75 FT
PP, PVDF, stainless steel
Type RM 3.1
Delivery rate:
2.2 to 63 GPM
Delivery head:
up to 59 FT
PP, PVDF
self-priming
Type RM 4
Delivery rate:
2.6 to 92.5 GPM
Delivery head:
up to 118 FT
PP, PVDF, stainless steel
Type RM 4.5
Delivery rate:
4.4 to 264 GPM
Delivery head:
up to 105 FT
PP, PVDF
Type RM 5
Delivery rate:
8.8 to 132 GPM
Delivery head:
up to 196 FT
PP, PVDF
