Constructional design

Housing, impeller, impeller magnet coating and rear casing can be made of either glass-fibre reinforced PP plastic or PVDF. Sleeve bearings, starting ring and centering shaft are made of 99.7% pure oxide ceramic. O-ring sealing of the housing is made of FPM or EPDM or FEP (optionally available).

• For aggressive and neutral liquids
• For short-term and continuous operation
• With non-ventilated motor so that it is insensitive to vapour.

The pump is available in:

• PP, PVDF
• Pump sizes 5/50 | 8/60 | 10/100 | 10/110

Motor:

• 230/400V three-phase motor or
• 230V single-phase ac capacitor start-and-run motor, 90 to 250 watts, 50 Hz, insulation class F, protection class IP 55 motor speed 2,850min-1
  – Other voltages and frequencies are available on request. –

Weight:

• approx. 8.8 to 16.5 LBS

Fluid temperature range:

• PP -4° to +176°F
• PVDF -4° to +203°F

Pressure range: **

• PP up to 36 PSI
• PVDF up to 50 PSI

Position of terminal box:

• vertical position is standard
• positions turned to the right or the left are possible

Position of discharge port:

• vertical position is standard
• differing positions of 6x60° are possible

Ports acc. to German DIN 8063 standard:

• suction port: d25/DN20 - G 1¼
• discharge port: d25/DN20 - G 1¼

Accessories (optional):

• explosion-proof motor (only with 180 and 250 watts capacity)
• motor circuit-breaker for 230/400V three-phase current
• connection cable 5m long with CEE-plug
• pilotherm for 230V ac
• ON/OFF switch with connection cable 2.5m long and plug for 230V ac
• flanges
• flexible hoses
• non-return valve
• three-piece hose connection (incl. hose nipple, spigot nut and O-ring)

* To deliver liquids with a higher relative density, we also offer all our pumps with smaller impeller diameters which, however, reduce delivery rates and heads of the pumps. If in doubt, please consult us.

** Maximum system pressure depends on the temperature of the fluid delivered.