Constructional design

Housing, impeller, impeller magnet coating and rear casing are made of either glass-fibre reinforced PP plastic or PVDF or stainless steel. Sleeve bearings, starting rings and centering shaft are made of 99.7% pure oxide ceramic. The impeller starting ring is made of PTFE graphite. O-ring sealing of the housing is made of FPM or EPDM or FEP (optionally available).

• For aggressive and neutral liquids
• For short-term and continuous operation

The pump is available in:

• PP, PVDF, stainless steel
• Pump sizes 9/350 | 18/240 | 20/300 | 24/340 | 27/400 | 30/400 | 35/200

Motor:

• 230/400V three-phase motor, 0.75 to 4.0kW, 50 Hz, insulation class F, protection class IP 54 motor speed 2,900min-1
  – Other voltages and frequencies are available on request. –

Weight:

• approx. 37 to 84 LBS

Fluid temperature range:

• PP -4° to +176°F
• PVDF -4° to +203°F
• steel -4° to +203°F

Pressure range: **

• PP up to 72.5 PSI
• PVDF up to 87 PSI
• steel up to 87 PSI

Position of terminal box:

• vertical position is standard
• positions turned to the right or the left are possible

Position of discharge port:

• vertical position is standard
• differing positions of 12x30° are possible

Ports acc. to German DIN 8063 standard:

• suction port: d50/DN40 - G2¼
• discharge port: d40/DN35 - G2

Accessories (optional):

• explosion-proof motor
• ac motor of up to 1.1kW
• three-phase motor with frequency converter
• motor circuit-breaker for 230/400V three-phase motor
• flanges
• non-return valve
• three-piece hose connection (incl. hose nipple, spigot nut and O-ring)

* To deliver liquids with a higher relative density, we also offer all our pumps with smaller impeller diameters which, however, reduce delivery rates and heads of the pumps. If in doubt, please consult us.

** Maximum system pressure depends on the temperature of the fluid delivered.